I’m really need some help with this one. My 2007 Yamaha golf cart’s solenoid isn’t clicking, and I’ve tried almost everything. Could really use some expert advice!
Response
You need to have the solenoid terinals checked to see if they have the correct voltage output.
Solutions that worked for users
| Solution | Users Who Found Success | Personal Experience | Estimated Cost (USD) | Time Needed (Minutes) |
|---|---|---|---|---|
| Check Solenoid Terminals | 3 | Checked terminals and it worked | $0 | 5-10 |
| Check Wire Coupler for Solenoid | 3 | Fixed wire coupler and it worked | $0 | 5-10 |
| Jump the Solenoid | 1 | Jumped the solenoid and it worked | $0 | 5-10 |
| Check for Reverse Buzzer and Controller | 1 | Checked reverse buzzer, found the issue | $0 | 5-10 |
| Check Tow/Run Switch and Wire Connections | 1 | Checked all switches and connections | $0 | 5-10 |
Symptoms
- Solenoid not clicking when the pedal is pressed
- Cart refusing to move even with a fully charged battery
- Complete lack of response from the cart, making it immobile
Possible Causes
- Faulty or damaged solenoid
- Poor wire connections or corroded terminals
- Defective or misaligned switches
- Controller issues
Solutions that Worked
1. Check Solenoid Terminals
What I Did:
Checked the solenoid terminals for proper voltage using a multimeter.
Outcome:
The solenoid started clicking, and the cart was back in action.
Personal Experience:
I was skeptical at first, but after checking the terminals, everything started working like a charm.
Estimated Cost:
$0
Time Needed:
5-10 minutes
Steps:
- Turn off the golf cart and disconnect the battery.
- Locate the solenoid, usually near the battery compartment.
- Use a multimeter set to DC voltage to check for voltage at the solenoid terminals.
- Reconnect the battery and turn on the cart to see if the issue is resolved.
Expert Tip:
Always start with the basics. A faulty solenoid often shows no voltage at the terminals. If you find voltage, the issue might be elsewhere.
2. Check Wire Coupler for Solenoid
What I Did:
Inspected the wire coupler connected to the solenoid.
Outcome:
The solenoid started clicking, and the cart moved.
Personal Experience:
I noticed some corrosion on the wire coupler. After cleaning it, the solenoid started clicking again.
Estimated Cost:
$0
Time Needed:
5-10 minutes
Steps:
- Turn off the golf cart and disconnect the battery.
- Locate the wire coupler for the solenoid.
- Inspect for any signs of corrosion, wear, or damage.
- Clean any corrosion using a wire brush or sandpaper.
- Reconnect the battery and test the cart.
Expert Tip:
Corrosion can silently disable your cart. Regularly inspect and clean all electrical connections, not just the solenoid.
Safety info
- Always disconnect the battery before performing any electrical work on your golf cart.
- If you’re not comfortable with electrical troubleshooting, don’t hesitate to consult a professional.
- Keep a multimeter handy. It’s an invaluable tool for diagnosing electrical issues.
- Some Yamaha models have a “Run/Tow” switch that needs to be in the “Run” position for the solenoid to operate. Make sure it’s in the correct position.
- In some cases, a faulty ignition switch can cause the solenoid not to click. It’s a less common issue but worth checking.
TV Models where this Worked
- 2003 Yamaha G22E
- 2002 Yamaha G22E
- 1997 Yamaha G16E
- 2007 Yamaha G29
- Yamaha G19