The TaylorMade R11 TP fairway wood uses FCT + Adjustable Sole Plate. Factory lofts range from 13° to 18°. Start at the standard setting and change one variable at a time.
TaylorMade Fairway Wood Adjustment Guide
R11 TP
FCT + Adjustable Sole Plate • 2011
FCT + ASPLoft adjustment
Legacy adjustableHosel system
13°–18°Factory loft
58°–59°Factory lie
Historical spec note: The source workbook marks these loft/lie figures as estimated or reconstructed. Use them as an era reference rather than an exact factory measurement for a specific surviving club.
Model note: This is the more player focused version of the family. Use the adjustable loft to preserve your preferred launch window rather than simply choosing the lowest setting.
Hosel settings
| FCT hosel | Adjusts loft and also changes lie / face orientation. |
|---|---|
| ASP sole plate | Lets you change how the face presents when the club is soled without changing the FCT sleeve position. |
| Important | Use the markings on the exact R11 adapter and sole plate. Do not substitute the later R11S 24-combination chart. |
Check strike before changing the club
| High face | Often raises launch and lowers spin. |
|---|---|
| Low face | Often lowers launch and adds spin. Check strike before adding loft. |
| Heel | Can add fade or slice gear effect. |
| Toe | Can add draw or hook gear effect. |
How to adjust the hosel
- Support the head and use the correct TaylorMade torque wrench.
- Loosen the hosel screw counter clockwise until the head releases.
- Rotate to a valid setting for this exact sleeve generation.
- Fully reseat the head before tightening.
- Tighten clockwise until the wrench clicks, then stop.
Best first changes
| More launch / spin | Increase loft one step and re-check strike. |
|---|---|
| Less launch / spin | Reduce loft one step before jumping to the minimum setting. |
| Right miss | More loft on modern sleeves generally presents the face more closed. Test start direction rather than treating the sleeve as a pure draw control. |
| Left miss | Less loft generally presents the face more open. Change one control at a time. |
Factory specs
| Loft specs | TS/3W 13°; 3W 15°; 5W 18° |
|---|---|
| Lie specs | TS/3W 58°; 3W 58.5°; 5W 59° |
Common mistakes
- Using a 4° sleeve chart on a 3° or older FCT sleeve.
- Continuing to tighten after the torque wrench clicks.
Disclaimer: TaylorMade sleeve systems vary by generation and club type. Confirm the exact adapter markings, supported head and compatible wrench for your club before loosening the head.