The TaylorMade Qi10 Tour Rescue hybrid uses 3° Loft Sleeve. Factory lofts range from 17° to 22°. Start at the standard setting and change one variable at a time.
TaylorMade Hybrid Adjustment Guide
Qi10 Tour Rescue
3° Loft Sleeve • 2024
±1.5° loftLoft adjustment
12 positionsHosel system
17°–22°Factory loft
56.5°–60.5°Factory lie
Model note: This is the more compact player focused rescue in its family; prioritize carry window and turf interaction over maximum forgiveness.
Hosel settings
| Position | Loft change | Lie direction |
|---|---|---|
| STD LOFT | 0° | Standard lie |
| +.5° | +0.5° | About 0.5° more upright |
| +1° | +1.0° | About 1° more upright |
| HIGHER | +1.5° | About 1.5° more upright |
| -.5° | -0.5° | About 0.5° more upright |
| -1° | -1.0° | About 1° more upright |
| LOWER | -1.5° | About 1.5° more upright |
| UPRT | Stated loft | About 3° upright |
The 3° TaylorMade rescue/fairway sleeve uses 12 positions across ±1.5° of loft. Intermediate positions move in 0.5° loft steps on current rescue sleeves; older sleeves should still be matched to their own adapter markings.
Check strike before changing the club
| High face | Often raises launch and lowers spin. |
|---|---|
| Low face | Often lowers launch and adds spin. Check strike before adding loft. |
| Heel | Can add fade or slice gear effect. |
| Toe | Can add draw or hook gear effect. |
How to adjust the hosel
- Support the head and use the correct TaylorMade torque wrench.
- Loosen the hosel screw counter clockwise until the head releases.
- Rotate to a valid setting for this exact sleeve generation.
- Fully reseat the head before tightening.
- Tighten clockwise until the wrench clicks, then stop.
Best first changes
| More launch / spin | Increase loft one step and re-check strike. |
|---|---|
| Less launch / spin | Reduce loft one step before jumping to the minimum setting. |
| Right miss | More loft on modern sleeves generally presents the face more closed. Test start direction rather than treating the sleeve as a pure draw control. |
| Left miss | Less loft generally presents the face more open. Change one control at a time. |
Factory specs
| Loft specs | 2 17°; 3 19.5°; 4 22° |
|---|---|
| Lie specs | 2 56.5°-59.5°; 3 57°-60°; 4 57.5°-60.5° |
Common mistakes
- Using a 4° sleeve chart on a 3° or older FCT sleeve.
- Continuing to tighten after the torque wrench clicks.
Disclaimer: TaylorMade sleeve systems vary by generation and club type. Confirm the exact adapter markings, supported head and compatible wrench for your club before loosening the head.