The TaylorMade GAPR HI hybrid uses 3° Loft Sleeve. Factory lofts range from 23° to 35°. Start at the standard setting and change one variable at a time.
TaylorMade Hybrid Adjustment Guide
GAPR HI
3° Loft Sleeve • 2018
±1.5° loftLoft adjustment
12 positionsHosel system
23°–35°Factory loft
59.5°–61°Factory lie
Historical spec note: The source workbook marks these loft/lie figures as estimated or reconstructed. Use them as an era reference rather than an exact factory measurement for a specific surviving club.
Model note: GAPR was designed to bridge the distance gap between the longest playable iron and shortest metalwood, so carry gapping should drive the loft setting.
Hosel settings
| Position | Loft change | Lie direction |
|---|---|---|
| STD LOFT | 0° | Standard lie |
| +.5° | +0.5° | About 0.5° more upright |
| +1° | +1.0° | About 1° more upright |
| HIGHER | +1.5° | About 1.5° more upright |
| -.5° | -0.5° | About 0.5° more upright |
| -1° | -1.0° | About 1° more upright |
| LOWER | -1.5° | About 1.5° more upright |
| UPRT | Stated loft | About 3° upright |
The 3° TaylorMade rescue/fairway sleeve uses 12 positions across ±1.5° of loft. Intermediate positions move in 0.5° loft steps on current rescue sleeves; older sleeves should still be matched to their own adapter markings.
Check strike before changing the club
| High face | Often raises launch and lowers spin. |
|---|---|
| Low face | Often lowers launch and adds spin. Check strike before adding loft. |
| Heel | Can add fade or slice gear effect. |
| Toe | Can add draw or hook gear effect. |
How to adjust the hosel
- Support the head and use the correct TaylorMade torque wrench.
- Loosen the hosel screw counter clockwise until the head releases.
- Rotate to a valid setting for this exact sleeve generation.
- Fully reseat the head before tightening.
- Tighten clockwise until the wrench clicks, then stop.
Best first changes
| More launch / spin | Increase loft one step and re-check strike. |
|---|---|
| Less launch / spin | Reduce loft one step before jumping to the minimum setting. |
| Right miss | More loft on modern sleeves generally presents the face more closed. Test start direction rather than treating the sleeve as a pure draw control. |
| Left miss | Less loft generally presents the face more open. Change one control at a time. |
Factory specs
| Loft specs | 4H 23°; 5H 27°; 6H 31°; 7H 35° |
|---|---|
| Lie specs | 4H 59.5°; 5H 60°; 6H 60.5°; 7H 61° |
Common mistakes
- Using a 4° sleeve chart on a 3° or older FCT sleeve.
- Continuing to tighten after the torque wrench clicks.
Disclaimer: TaylorMade sleeve systems vary by generation and club type. Confirm the exact adapter markings, supported head and compatible wrench for your club before loosening the head.