The PING G410 fairway wood uses Trajectory Tuning 2.0. Factory loft range from 14.5° to 23.5°. Start at the standard setting and change one control at a time.
PING Fairway Wood Adjustment Guide
G410
Trajectory Tuning 2.0 • 2019
±1.5°Loft adjustment
8 positionsHosel settings
14.5°–23.5°Factory loft
56°–57.5°Factory lie
Exact hosel settings
| Standard dot | 0° loft change; standard lie family |
|---|---|
| Small + | +1.0° loft |
| Big + | +1.5° loft |
| Small – | -1.0° loft |
| Big – | -1.5° loft |
| F | Stated loft; flat lie |
| F+ | +1.0° loft; flat lie |
| F- | -1.0° loft; flat lie |
Trajectory Tuning 2.0 provides eight positions, ±1.5° loft adjustment and lie settings up to about 3° flatter than standard.
Check strike before changing the club
| High face | Often raises launch and lowers spin. |
|---|---|
| Low face | Often lowers launch and adds spin. Check strike before adding loft. |
| Heel | Can add fade or slice gear effect. |
| Toe | Can add draw or hook gear effect. |
How to adjust the hosel
- Support the head and use the correct PING torque wrench.
- Loosen the hosel screw counter clockwise until the head releases.
- Align the desired setting for this exact hosel generation.
- Fully reseat the head.
- Tighten clockwise until the wrench clicks, then stop.
Best first changes
| More launch | Add loft one step and re-check strike. |
|---|---|
| Less launch or spin | Reduce loft one step before using the lowest setting. |
| Right miss | Use the standard lie family first; avoid the flat F settings if they move start direction farther right. |
| Left miss | The F flat family can be useful when a flatter lie suits the delivery. |
Factory specs
| Loft specs | 3W 14.5°; 5W 17.5°; 7W 20.5°; 9W 23.5° |
|---|---|
| Lie specs | 3W 56°; 5W 56.5°; 7W 57°; 9W 57.5° |
Common mistakes
- Using the chart from the wrong PING hosel generation.
- Changing several settings before testing the first change.
- Continuing to tighten after the torque wrench clicks.
Disclaimer: Hosel settings can vary by generation and configuration. Confirm the correct PING wrench and adjustment chart for your exact club before loosening the head.