The Mizuno ST200 Fairway fairway wood lie angles run from 58°–59.5°. The model’s lie progression spans 1.5° with lie steps of 0.5°–1°.
Fairway Wood • Released 2020
ST200 Fairway lie-angle fingerprint
What stands out about the ST200 Fairway lie setup?
The ST200 Fairway moves from 58° in the 3-wood to 59.5° in the 7-wood, a total lie progression of 1.5°.
The biggest single lie step is 1° between the 3-wood and 5-wood. Elsewhere the progression tightens to as little as 0.5°.
For fitting, the 5-wood at 59° is the most useful mid-set reference before checking the rest of the set.
For this fairway-wood family, lie fitting is more about strike pattern, delivery and address fit than creating a large left/right correction.
Any lie change should come only from the indexed Mizuno hosel positions supported by this exact adapter.
Factory lie angle chart
| Club | Lie | Step | Progression |
|---|---|---|---|
| 3-wood | 58° | — | Starting lie |
| 5-wood | 59° | +1° | Typical step |
| 7-wood | 59.5° | +0.5° | Typical step |
Lie progression by club
ST200 Fairway directional effect from a 1° lie error
Where to focus your dynamic lie test on the ST200 Fairway
Use 5-wood at 59° as the baseline because it gives a representative mid-set delivery check.
7-wood (21° loft), 5-wood (18° loft), 3-wood (15° loft). Their higher loft makes the same lie error more directionally visible.
3-wood (15° loft), 5-wood (18° loft). Use them to confirm the fit still works through the long end of the set.
Dynamic lie test for the Mizuno ST200 Fairway
If the head has an indexed Quick Switch sleeve, use only its supported lie relationships.
If there is no indexed sleeve, treat the lie as fixed and test the head as-is.
A bonded fairway-wood hosel should not be bent to chase a lie number.
How to evaluate the Mizuno ST200 Fairway dynamic lie fit
Use the factory or neutral hosel position as the baseline.
Track repeated strike location rather than judging one heel or toe strike.
Separate start direction from curvature. A face / path problem is not automatically a lie problem.
Use indexed adapter settings where available. Do not bend a fixed wood or hybrid head.
Should the Mizuno ST200 Fairway be more upright or flatter?
A more upright fit may help when…
- A fitter confirms the stock head sits too flat dynamically
- Another factory / supported head produces better centre contact
A flatter fit may help when…
- A fitter confirms the stock head sits too upright dynamically
- Another factory / supported head produces better centre contact
Do not change lie just because…
- You plan to bend a fixed head
- You are using lie as a substitute for swing or strike work
- You have no repeatable baseline
Can the Mizuno ST200 Fairway lie angle be adjusted?
If there is an indexed Mizuno sleeve, use only its supported positions. If the hosel is fixed, do not bend it.
Why shaft length can change the lie fit
Playing length changes posture, hand height and delivery, so the same static lie can fit differently after a length change. Re-test dynamic lie after changing playing length rather than automatically adding or subtracting a fixed number of lie degrees.
Static lie is only the starting specification. Dynamic lie changes with delivery, shaft deflection, playing length and setup. Mizuno states that iron lie adjustment varies by model and material, while drivers and fairway woods are not bent for loft or lie. Before bending a club or rotating an indexed hosel, confirm the instructions for your exact model with Mizuno or a qualified fitter. Mizuno custom specifications.