The gasoline E-Z-GO Workhorse 1000 utility vehicle uses a low-pressure three-line fuel-pump layout: tank supply to pump inlet, pump outlet to the carburetor, and an engine pulse/impulse line to the diaphragm pump.
Workhorse 1000 • Fuel pump hose routing
Workhorse 1000 fuel-line routing at a glance
No fuel at pump
Check tank pickup, filter and supply hose.
Pump new but dry
Recheck inlet, outlet and pulse ports.
Starves under load
Inspect pulse hose and suction-side restriction.
Use destinations
Do not identify hoses by colour alone.
How the E-Z-GO Workhorse 1000 fuel lines are routed
Common Workhorse 1000 hose-routing mistakes
Swapped inlet/outlet
A diaphragm pump may not draw or deliver fuel if the supply and outlet connections are reversed.
Fuel hose on pulse port
The pulse/impulse port is driven by engine pressure pulses; connecting a fuel line there prevents correct operation.
Leaking pulse hose
A split or loose pulse hose can make a good pump appear faulty.
Collapsed suction hose
Old soft hose can flatten under suction and cause load-related starvation.
Workhorse 1000 fuel hose and line layout
Pump/system: Low-pressure pulse/diaphragm pump.
Engine/system: Legacy E-Z-GO gasoline / carbureted.
Routing: Fuel tank → pump inlet; pump outlet → carburetor; engine pulse source → diaphragm-pump pulse port.
Applies to: Legacy gasoline.
Model-specific note
Legacy E-Z-GO gasoline vehicles in this family commonly use a three-line low-pressure pulse-pump layout.
E-Z-GO Workhorse 1000 fuel hose FAQ
How are the E-Z-GO Workhorse 1000 fuel-pump hoses routed?
On gasoline versions of the E-Z-GO Workhorse 1000 utility vehicle, route fuel from the tank to the pump inlet, from the pump outlet to the carburetor, and connect the engine pulse/impulse source to the pump pulse port.
Which hose is the pulse line on the E-Z-GO Workhorse 1000?
It is the non-fuel hose that runs from the engine/crankcase pulse source to the diaphragm pump. Trace the hose by destination rather than colour.
What happens if the E-Z-GO Workhorse 1000 pump hoses are backwards?
Reversing inlet, outlet or pulse connections can stop fuel delivery or make a replacement pump appear faulty.
Can a bad pulse hose cause E-Z-GO Workhorse 1000 fuel starvation?
Yes. A split, loose, blocked or collapsing pulse/impulse hose can reduce diaphragm-pump output, especially under load.
Should old fuel hose be replaced on a E-Z-GO Workhorse 1000?
Replace hose that is cracked, hardened, swollen, soft, loose on its fitting or incorrectly routed.
Can I identify E-Z-GO Workhorse 1000 fuel-pump hoses by colour?
No. Hose colours change with repairs. Identify the tank supply, carburetor outlet and pulse line by where each one connects.
Fuel-line routing, pump type, connectors and pressure requirements can vary by model year, engine and serial range. Before disconnecting or replacing any line, confirm the routing in the official owner, operator, parts or service manual for your exact E-Z-GO Workhorse 1000. For current documentation, visit the official manufacturer website.