The Cobra King F6 Fairway runs from 42.25 in (107.3 cm) for the 7-8W to 43.25 in (109.9 cm) for the 3-4W.
Cobra King F6 Fairway length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 3-4W | 43.25 in | 109.9 cm |
| 5-6W | 42.75 in | 108.6 cm |
| 7-8W | 42.25 in | 107.3 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
King F6 Fairway club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 5 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra King F6 Fairway length FAQs
What is the King F6 Fairway length range?
The listed lengths run from 42.25 in (107.3 cm) to 43.25 in (109.9 cm), a total spread of 1 in (2.54 cm). The longest listed club is 3-4W and the shortest is 7-8W.
How long is the King F6 Fairway 5-6W?
The listed 5-6W playing length is 42.75 in (108.6 cm). Across this model, that sits 0.5 in below the longest listed club.
How does length change through the King F6 Fairway set?
The listed progression generally gets shorter as loft increases. The typical step between adjacent listed clubs is about 0.5 in (1.27 cm), with a full longest-to-shortest change of 1 in.
How do loft and length relate in the King F6 Fairway set?
For the matched entries in this dataset, 3-4W is 13° at 43.25 in (109.9 cm), while 3-4W is 13° at 43.25 in (109.9 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the King F6 Fairway length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.