The Cobra King Cobra Driver has a listed playing length of 45 in (114.3 cm).
Cobra King Cobra length chart
Playing length in inches and centimetres.
| Specification | Length (in) | Length (cm) |
|---|---|---|
| Driver | 45 in | 114.3 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length at a glance
A simple view of the listed playing length.
King Cobra playing length
The single listed playing length at a glance.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Shorter than median
Based on 148 other Cobra men/unisex driver entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra King Cobra length FAQs
What is the King Cobra Driver playing length?
The listed Driver playing length is 45 in (114.3 cm). This is the 1994 men/unisex specification represented in this dataset.
How does the King Cobra length compare with other Cobra drivers?
Its listed 45 in (114.3 cm) length is 0.5 in shorter than the 45.5 in median used in the like-for-like Cobra dataset benchmark on this page.
Does the King Cobra driver length change with loft?
The master row lists loft option(s) of 9, 10.5° and one reference playing length of 45 in (114.3 cm). It does not provide separate finished lengths for each loft, so the page does not invent a loft-by-loft difference.
What lie specification is paired with the King Cobra length data?
The master row lists lie specification(s) of 55 degrees. Length and lie should be checked together when trying to reproduce the original 1994 build.
Is the King Cobra length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.