The Cobra FP Women’s Iron Set runs from 34.25 in (87 cm) for the SW to 37.5 in (95.2 cm) for the 4-iron.
Cobra FP Women’s length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 4-iron | 37.5 in | 95.2 cm |
| 5-iron | 37 in | 94 cm |
| 6-iron | 36.5 in | 92.7 cm |
| 7-iron | 36 in | 91.4 cm |
| 8-iron | 35.5 in | 90.2 cm |
| 9-iron | 35 in | 88.9 cm |
| PW | 34.75 in | 88.3 cm |
| GW | 34.5 in | 87.6 cm |
| SW | 34.25 in | 87 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
FP Women’s club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra FP Women's length FAQs
What is the FP Women's length range?
The listed lengths run from 34.25 in (87 cm) to 37.5 in (95.2 cm), a total spread of 3.25 in (8.26 cm). The longest listed club is 4-iron and the shortest is SW.
How long is the FP Women's 7-iron?
The listed 7-iron playing length is 36 in (91.4 cm). Across this model, that sits 1.5 in below the longest listed club.
How does length change through the FP Women's set?
The listed progression generally gets shorter as loft increases. The typical step between adjacent listed clubs is about 0.5 in (1.27 cm), with a full longest-to-shortest change of 3.25 in.
How do loft and length relate in the FP Women's set?
For the matched entries in this dataset, 4-iron is 22° at 37.5 in (95.2 cm), while SW is 54° at 34.25 in (87 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the FP Women's length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.