The Cobra Fly-Z XL Fairway runs from 41.5 in (105.4 cm) for the 7W to 43 in (109.2 cm) for the 3W.
Cobra Fly-Z XL Fairway length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 3W | 43 in | 109.2 cm |
| 5W | 42 in | 106.7 cm |
| 7W | 41.5 in | 105.4 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
Fly-Z XL Fairway club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 66 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Near dataset median
Based on 66 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Near dataset median
Based on 56 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Fly-Z XL Fairway length FAQs
What is the Fly-Z XL Fairway length range?
The listed lengths run from 41.5 in (105.4 cm) to 43 in (109.2 cm), a total spread of 1.5 in (3.81 cm). The longest listed club is 3W and the shortest is 7W.
How long is the Fly-Z XL Fairway 3W?
The listed 3W playing length is 43 in (109.2 cm). It matches the model’s longest listed length.
How does length change through the Fly-Z XL Fairway set?
The listed progression generally gets shorter as loft increases. The typical step between adjacent listed clubs is about 0.75 in (1.91 cm), with a full longest-to-shortest change of 1.5 in.
How do loft and length relate in the Fly-Z XL Fairway set?
For the matched entries in this dataset, 3W is 16° at 43 in (109.2 cm), while 7W is 22° at 41.5 in (105.4 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the Fly-Z XL Fairway length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.