The Cobra Baffler XL Driver has a listed playing length of 45.5 in (115.6 cm).
Cobra Baffler XL length chart
Playing length in inches and centimetres.
| Specification | Length (in) | Length (cm) |
|---|---|---|
| Driver | 45.5 in | 115.6 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length at a glance
A simple view of the listed playing length.
Baffler XL playing length
The single listed playing length at a glance.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 148 other Cobra men/unisex driver entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Baffler XL length FAQs
What is the Baffler XL Driver playing length?
The listed Driver playing length is 45.5 in (115.6 cm). This is the 2014 men/unisex specification represented in this dataset.
How does the Baffler XL length compare with other Cobra drivers?
Its listed 45.5 in (115.6 cm) length matches the 45.5 in median used in the like-for-like Cobra dataset benchmark on this page.
Does the Baffler XL driver length change with loft?
The master row lists loft option(s) of 10.5, 11.5, 12° and one reference playing length of 45.5 in (115.6 cm). It does not provide separate finished lengths for each loft, so the page does not invent a loft-by-loft difference.
What lie specification is paired with the Baffler XL length data?
The master row lists lie specification(s) of 59 degrees. Length and lie should be checked together when trying to reproduce the original 2014 build.
Is the Baffler XL length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.