The Cobra Baffler DWS Women’s Utility runs from 38.5 in (97.8 cm) for the 5H to 40 in (101.6 cm) for the 2H.
Cobra Baffler DWS Women’s Utility length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 2H | 40 in | 101.6 cm |
| 3H | 39.5 in | 100.3 cm |
| 4H | 39 in | 99.1 cm |
| 5H | 38.5 in | 97.8 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
Baffler DWS Women’s Utility club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Baffler DWS Women's Utility length FAQs
What is the Baffler DWS Women's Utility length range?
The listed lengths run from 38.5 in (97.8 cm) to 40 in (101.6 cm), a total spread of 1.5 in (3.81 cm). The longest listed club is 2H and the shortest is 5H.
How long is the Baffler DWS Women's Utility 3H?
The listed 3H playing length is 39.5 in (100.3 cm). Across this model, that sits 0.5 in below the longest listed club.
How does length change through the Baffler DWS Women's Utility set?
The listed progression generally gets shorter as loft increases. The typical step between adjacent listed clubs is about 0.5 in (1.27 cm), with a full longest-to-shortest change of 1.5 in.
How do loft and length relate in the Baffler DWS Women's Utility set?
For the matched entries in this dataset, 2H is 18° at 40 in (101.6 cm), while 5H is 26° at 38.5 in (97.8 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the Baffler DWS Women's Utility length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.