The Cobra 3DP Tour Agera Counterbalance Putter has a listed playing length of 38 in (96.5 cm).
Cobra 3DP Tour Agera Counterbalance length chart
Playing length in inches and centimetres.
| Specification | Length (in) | Length (cm) |
|---|---|---|
| Putter | 38 in | 96.5 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length at a glance
A simple view of the listed playing length.
3DP Tour Agera Counterbalance playing length
The single listed playing length at a glance.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Shorter than median
Based on 7 other Cobra men/unisex putter entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra 3DP Tour Agera Counterbalance length FAQs
What is the 3DP Tour Agera Counterbalance Putter playing length?
The listed Putter playing length is 38 in (96.5 cm). This is the 2026 men/unisex specification represented in this dataset.
How does the 3DP Tour Agera Counterbalance length compare with other Cobra putters?
Its listed 38 in (96.5 cm) length is 3 in shorter than the 41 in median used in the like-for-like Cobra dataset benchmark on this page.
What lie specification is paired with the 3DP Tour Agera Counterbalance length data?
The master row lists lie specification(s) of 70 degrees. Length and lie should be checked together when trying to reproduce the original 2026 build.
What loft specification goes with this 3DP Tour Agera Counterbalance length?
The master row lists loft option(s) of 4 degrees. The page uses the length values attached to that same 2026 model entry.
Is the 3DP Tour Agera Counterbalance length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.