The Cobra 3D Printed Supernova Putter runs from 34 in (86.4 cm) for the Length option 1 to 35 in (88.9 cm) for the Length option 2.
Cobra 3D Printed Supernova length chart
Playing length in inches and centimetres.
| Specification | Length (in) | Length (cm) |
|---|---|---|
| Length option 1 | 34 in | 86.4 cm |
| Length option 2 | 35 in | 88.9 cm |
The source data lists multiple length choices without assigning each one to a specific club/head label, so the page keeps them as numbered options rather than inventing a mapping.
Length progression
A quick visual of the listed length progression within this model.
3D Printed Supernova club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra 3D Printed Supernova length FAQs
What is the 3D Printed Supernova length range?
The listed lengths run from 34 in (86.4 cm) to 35 in (88.9 cm), a total spread of 1 in (2.54 cm).
How many different lengths are listed for the 3D Printed Supernova?
There are 2 distinct playing lengths across 2 listed configurations.
What lie specification is paired with the 3D Printed Supernova length data?
The master row lists lie specification(s) of 70 degrees. Length and lie should be checked together when trying to reproduce the original 2024 build.
What loft specification goes with this 3D Printed Supernova length?
The master row lists loft option(s) of 4 degrees. The page uses the length values attached to that same 2024 model entry.
Is the 3D Printed Supernova length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.