The Callaway RAZR Fit Xtreme Fairway uses 8-way OptiFit on the adjustable configuration. Factory loft coverage is 15°–24°. Confirm that your exact head has the hosel screw before using this chart.
Callaway Fairway Wood Adjustment Guide
RAZR Fit Xtreme Fairway
8-way OptiFit • 2013
57°–58.5°Factory lie specs
WrenchAdjustment method
Exact hosel settings
| -1 | 1° lower than stated loft |
|---|---|
| S | Stated loft |
| +1 | 1° above stated loft |
| +2 | 2° above stated loft |
| N | Neutral lie |
| D | More upright/draw lie |
Check strike before changing the club
| High face | Often raises launch and lowers spin. Do not keep raising the tee if flight is already high. |
|---|---|
| Low face | Often lowers launch and adds spin. Raise tee height slightly before changing loft. |
| Heel | Can add fade/slice gear effect. Improve centred contact before adding draw bias. |
| Toe | Can add draw/hook gear effect. Check strike before adding fade bias. |
How to adjust
- Use the correct Callaway torque wrench.
- Loosen counter-clockwise until the head separates.
- Rotate to a valid setting for this hosel generation.
- Fully reseat the head and align the marks.
- Tighten until the wrench clicks, then stop.
Best first changes
| More launch | Add loft one step first. |
|---|---|
| Less launch/spin | Reduce loft one step first. |
| Right miss | Use the more upright/draw direction only after strike is centred. |
| Left miss | Use the flatter/neutral direction where the hosel provides it. |
Factory specs
| Loft specs | 3W:15°; 4W:17°; 5W:19°; 7W:21°; additional spec not reliably published |
|---|---|
| Lie specs | 3W:57°; 4W:57.5°; 5W:58°; 7W:58.5°; additional spec not reliably published |
Disclaimer: Hosel systems, adjustable lofts and removable weights can vary by loft, handedness, model year and regional configuration. Before loosening any screw, confirm the exact settings and compatible wrench in official Callaway documentation for your exact club.