The Bushnell Tour V2 rangefinder has a listed laser-ranging accuracy of ±1 yd. On the course, its published flag range is 325 yd, PinSeeker helps with target acquisition, and the listed maximum laser range is 1000 yd.
Laser • Released 2008
Tour V2 accuracy by distance
Up to 1000 yd. Flag range: 325 yd.
What this means on the course
The Tour V2 uses a single published tolerance of ±1 yd rather than separate short- and long-range accuracy bands.
Its listed flag range is 325 yd, which is the more useful golf-specific range figure because a flag is much smaller than a large reflective target.
The listed maximum laser range is 1000 yd. That is a reach specification, not a promise that every target is equally easy to acquire at that distance.
Target acquisition and aiming
PinSeeker helps confirm that the laser acquired the intended target. It improves target selection confidence, not the published numeric tolerance.
5x provides less enlargement than a 6x or 7x optic, so careful aim and target-acquisition behavior matter more on a thin flagstick.
Accuracy vs repeatability vs display precision
Accuracy is closeness to the true distance within the stated tolerance.
Repeatability is how closely repeated readings agree when you aim at the same target.
Readout precision is how finely the number is displayed. Fine display increments do not automatically mean the laser is accurate to that same increment.
What can affect the reading?
Small or low-reflectivity targets are harder to isolate than large bright objects, especially when there is background clutter.
Bright sun, mist, rain and target angle can make acquisition less consistent even when the device is functioning normally.
If a number looks implausible, re-range the same target from the same position before treating it as a calibration problem.
Tour V2 accuracy troubleshooting
PinSeeker does not confirm the flag
Sweep slowly across the flag or flagstick. Target-confirmation feedback helps identify the intended target; it is not a separate accuracy measurement.
Repeated readings differ slightly
Keep the same aim point and take several readings. Small variation inside the published tolerance can be normal; a large repeatable offset is more meaningful.
Yards and metres seem mixed up
Check the unit setting. 100 yd is about 91.4 m, so a unit mix-up creates an error far larger than normal laser tolerance.
Long-range reading is difficult to obtain
At longer range the target occupies less of the view and target reflectivity, hand movement and background clutter matter more.
Bushnell Tour V2 accuracy FAQ
What accuracy tolerance does the Tour V2 rangefinder use?
Bushnell lists the Tour V2 at ±1 yd accuracy.
What does ±1 yd accuracy mean on the Tour V2?
A reading can fall within roughly ±1 yd of the true laser-measured distance while still meeting the published tolerance. Target size, aim and conditions can still affect real-world readings.
What is the useful golf range of the Tour V2?
The listed flag range is 325 yd, while the maximum laser range is 1000 yd. The flag figure is usually more relevant on a golf course because a flagstick is a much smaller target than a large reflective object.
Does PinSeeker improve the Tour V2’s target acquisition?
The PinSeeker feature is designed to help identify or confirm the intended target. It can make pin acquisition easier, but it does not change the laser’s stated numeric accuracy tolerance.
Does the 5x optic make the Tour V2 more accurate?
The 5x magnification enlarges the target to help you aim and hold on a flag or other object. It can improve practical target acquisition, but optical magnification does not alter the published laser tolerance.
Accuracy wording and test conditions can vary by generation. Open the model/source page.