The Blue Tees Golf Series 2 Pro+ rangefinder has a listed laser-ranging accuracy of ±1 yd. On the course, its published flag range is 250 yd, pin lock with vibration helps with target acquisition, and the listed maximum laser range is 800 yd.
Laser • Released 2021
Series 2 Pro+ accuracy by distance
Up to 800 yd. Flag range: 250 yd.
What this means on the course
The Series 2 Pro+ uses a single published tolerance of ±1 yd rather than separate short- and long-range accuracy bands.
Its listed flag range is 250 yd, which is the more useful golf-specific range figure because a flag is much smaller than a large reflective target.
The listed maximum laser range is 800 yd. That is a reach specification, not a promise that every target is equally easy to acquire at that distance.
Target acquisition and aiming
Pin lock with vibration helps confirm that the laser acquired the intended target. It improves target selection confidence, not the published numeric tolerance.
6x magnification gives useful target enlargement for aiming; optical magnification and laser accuracy remain separate specifications.
Accuracy vs repeatability vs display precision
Accuracy is closeness to the true distance within the stated tolerance.
Repeatability is how closely repeated readings agree when you aim at the same target.
Readout precision is how finely the number is displayed. Fine display increments do not automatically mean the laser is accurate to that same increment.
What can affect the reading?
Small or low-reflectivity targets are harder to isolate than large bright objects, especially when there is background clutter.
Bright sun, mist, rain and target angle can make acquisition less consistent even when the device is functioning normally.
If a number looks implausible, re-range the same target from the same position before treating it as a calibration problem.
The Series 2 Pro+ is listed as Water resistant. Environmental protection does not guarantee unchanged laser performance through rain droplets or fog.
Series 2 Pro+ accuracy troubleshooting
Pin lock with vibration does not confirm the flag
Sweep slowly across the flag or flagstick. Target-confirmation feedback helps identify the intended target; it is not a separate accuracy measurement.
Repeated readings differ slightly
Keep the same aim point and take several readings. Small variation inside the published tolerance can be normal; a large repeatable offset is more meaningful.
Yards and metres seem mixed up
Check the unit setting. 100 yd is about 91.4 m, so a unit mix-up creates an error far larger than normal laser tolerance.
Slope distance does not match straight-line distance
That can be normal. Compare the raw/actual laser distance when checking ranging accuracy; slope-adjusted distance intentionally changes the number.
Blue Tees Golf Series 2 Pro+ accuracy FAQ
What accuracy tolerance does the Series 2 Pro+ rangefinder use?
The published laser-ranging tolerance is ±1 yd.
What does ±1 yd accuracy mean on the Series 2 Pro+?
A reading can fall within roughly ±1 yd of the true laser-measured distance while still meeting the published tolerance. Target size, aim and conditions can still affect real-world readings.
How far can the Series 2 Pro+ range a flag compared with its maximum range?
The listed flag range is 250 yd, while the maximum laser range is 800 yd. The flag figure is usually more relevant on a golf course because a flagstick is a much smaller target than a large reflective object.
Does Pin lock with vibration improve the Series 2 Pro+’s target acquisition?
The Pin lock with vibration feature is designed to help identify or confirm the intended target. It can make pin acquisition easier, but it does not change the laser’s stated numeric accuracy tolerance.
Does the 6x optic make the Series 2 Pro+ more accurate?
The 6x magnification enlarges the target to help you aim and hold on a flag or other object. It can improve practical target acquisition, but optical magnification does not alter the published laser tolerance.
Accuracy wording and test conditions can vary by generation. Open the model/source page.