The Cobra Fly-Z Fairway runs from 43 in (109.2 cm) for the 5-7W to 43.5 in (110.5 cm) for the 3-4W.
Cobra Fly-Z Fairway length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 3-4W | 43.5 in | 110.5 cm |
| 5-7W | 43 in | 109.2 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
Fly-Z Fairway club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 5 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Fly-Z Fairway length FAQs
What is the Fly-Z Fairway length range?
The listed lengths run from 43 in (109.2 cm) to 43.5 in (110.5 cm), a total spread of 0.5 in (1.27 cm). The longest listed club is 3-4W and the shortest is 5-7W.
How long is the Fly-Z Fairway 5-7W?
The listed 5-7W playing length is 43 in (109.2 cm). Across this model, that sits 0.5 in below the longest listed club.
How many different lengths are listed for the Fly-Z Fairway?
There are 2 distinct playing lengths across 2 listed configurations.
How do loft and length relate in the Fly-Z Fairway set?
For the matched entries in this dataset, 3-4W is 13° at 43.5 in (110.5 cm), while 5-7W is 17° at 43 in (109.2 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the Fly-Z Fairway length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.