The PING G730 is a iron set launched around 2024. The set runs from 21.5° in the 5-iron to 24.5° in the 6-iron, while standard lengths taper from 38.5 to 37.75 in.
Key specifications
Iron-by-iron specifications
Each documented club is shown on its own row so the set progression is easy to scan.
| Club | Loft | Length | Lie | Bounce | Offset |
|---|---|---|---|---|---|
| 5 | 21.5° | 38.5 in | 61° | 6° | 0.26 in |
| 6 | 24.5° | 37.75 in | 61.5° | 7° | 0.23 in |
PING G730 build profile
Model information
| Launch year | 2024 |
|---|---|
| Club type | Iron set |
| Market | USA |
| U.S. status | current/listed by PING USA |
PING G730 FAQ
Does the PING G730 have much offset?+
The offset value is not reliably documented in this record.
Is the PING G730 lie angle upright or flat for PING?+
The lie value is not sufficiently documented for a useful same-type comparison.
Is the PING G730 long or short for its category?+
The length is not sufficiently documented for a useful same-type comparison.
How old is the PING G730?+
The audited record places its launch around 2024. That makes it roughly 2 years old in 2026. Condition, shaft integrity and whether the club was altered since new can matter as much as the original spec sheet on an older club.
Specification note: PING specifications can vary by generation, loft, shaft, market, fitting configuration and custom order. Historical models may be documented only by surviving catalog, retailer or observed-club evidence. Blank fields are intentionally left blank rather than guessed. Verify critical fitting or purchase details against an official PING specification source where available. Primary researched source.