The Callaway S2H2 ’90 Irons lie angles run from 59.25°–64°, with the listed heads spanning 59.25° to 64°. The supplied lie data is marked as estimated, so use it as a reference and verify the exact head before any permanent change.
Irons • Released 1990
S2H2 '90 lie-angle fingerprint
What stands out about the S2H2 '90 lie setup?
The S2H2 '90 runs from 59.25° at the 2 to 64° at the SW.
Lie steps vary from 0.5° to 0.75°, so the progression is not perfectly uniform.
There is 1 repeated lie value.
For dynamic fitting, 7-iron at 62° is the best central reference.
The supplied lie values are marked as estimated, so treat them as a reference rather than confirmed factory measurements.
Higher-loft short irons are more directionally sensitive to the same lie error, so check the fit through the set instead of relying on only one club.
Any lie change should be made by a qualified fitter with a loft-and-lie machine.
Estimated lie angle reference
| Club / head | Lie | Step | Pattern |
|---|---|---|---|
| 2 | 59.25° | — | Starting lie |
| 3-iron | 60° | +0.75° | Larger step |
| 4-iron | 60.5° | +0.5° | Typical step |
| 5-iron | 61° | +0.5° | Typical step |
| 6-iron | 61.5° | +0.5° | Typical step |
| 7-iron | 62° | +0.5° | Typical step |
| 8-iron | 62.5° | +0.5° | Typical step |
| 9-iron | 63° | +0.5° | Typical step |
| PW | 63.5° | +0.5° | Typical step |
| AW | 64° | +0.5° | Typical step |
| SW | 64° | 0° | Same lie |
Estimated lie progression visual
S2H2 '90 directional effect from a 1° lie error
Dynamic lie test for the Callaway S2H2 '90 7-iron
Test only if the head is safe to bend and dynamic evidence points upright.
Record strike and start direction before changing anything.
Keep setup and ball position consistent so the comparison is meaningful.
Should the Callaway S2H2 '90 be more upright or flatter?
Test more upright when…
- Toe is consistently down at impact
- Centred shots start right despite stable delivery
Test flatter when…
- Heel is consistently down at impact
- Centred shots start left despite stable delivery
Do not change lie just because…
- Strike pattern is inconsistent
- Playing length or face/path is the real issue
Playing length reference
| Club / head | Length |
|---|---|
| 2 | 39.5 in |
| 3-iron | 39 in |
| 4-iron | 38.5 in |
| 5-iron | 38 in |
| 6-iron | 37.5 in |
| 7-iron | 37 in |
| 8-iron | 36.5 in |
| 9-iron | 36 in |
| PW | 35.75 in |
| AW | 35.5 in |
| SW | 35.25 in |
Because these heads use different playing lengths, judge dynamic lie with the actual club being fit rather than applying one correction across the family.
Dynamic lie changes with delivery, shaft deflection, playing length and setup. If a Callaway wood or hybrid is adjustable, use only the documented hosel positions for that exact head. For irons, use a qualified club fitter before bending. Visit Callaway Golf.