The Cobra King SpeedZone Tour Fairway runs from 42.5 in (108 cm) for the 5W to 43.25 in (109.9 cm) for the 3W.
Cobra King SpeedZone Tour Fairway length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 3W | 43.25 in | 109.9 cm |
| 5W | 42.5 in | 108 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
King SpeedZone Tour Fairway club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 66 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Longer than median
Based on 66 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra King SpeedZone Tour Fairway length FAQs
What is the King SpeedZone Tour Fairway length range?
The listed lengths run from 42.5 in (108 cm) to 43.25 in (109.9 cm), a total spread of 0.75 in (1.91 cm). The longest listed club is 3W and the shortest is 5W.
How long is the King SpeedZone Tour Fairway 3W?
The listed 3W playing length is 43.25 in (109.9 cm). It matches the model’s longest listed length.
How many different lengths are listed for the King SpeedZone Tour Fairway?
There are 2 distinct playing lengths across 2 listed configurations.
How do loft and length relate in the King SpeedZone Tour Fairway set?
For the matched entries in this dataset, 3W is 14° at 43.25 in (109.9 cm), while 5W is 17.5° at 42.5 in (108 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the King SpeedZone Tour Fairway length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.