The Cobra Fly-Z+ Forged Iron Set runs from 35.75 in (90.8 cm) for the PW to 38.5 in (97.8 cm) for the 4-iron.
Cobra Fly-Z+ Forged length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 4-iron | 38.5 in | 97.8 cm |
| 5-iron | 38 in | 96.5 cm |
| 6-iron | 37.5 in | 95.2 cm |
| 7-iron | 37 in | 94 cm |
| 8-iron | 36.5 in | 92.7 cm |
| 9-iron | 36 in | 91.4 cm |
| PW | 35.75 in | 90.8 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
Fly-Z+ Forged club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 115 other Cobra men/unisex iron set entries with the same club label and ONE-length status in this dataset.
Near dataset median
Based on 115 other Cobra men/unisex iron set entries with the same club label and ONE-length status in this dataset.
Near dataset median
Based on 116 other Cobra men/unisex iron set entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Fly-Z+ Forged length FAQs
What is the Fly-Z+ Forged length range?
The listed lengths run from 35.75 in (90.8 cm) to 38.5 in (97.8 cm), a total spread of 2.75 in (6.99 cm). The longest listed club is 4-iron and the shortest is PW.
How long is the Fly-Z+ Forged 7-iron?
The listed 7-iron playing length is 37 in (94 cm). Across this model, that sits 1.5 in below the longest listed club.
How does length change through the Fly-Z+ Forged set?
The listed progression generally gets shorter as loft increases. The typical step between adjacent listed clubs is about 0.5 in (1.27 cm), with a full longest-to-shortest change of 2.75 in.
How do loft and length relate in the Fly-Z+ Forged set?
For the matched entries in this dataset, 4-iron is 21° at 38.5 in (97.8 cm), while PW is 45° at 35.75 in (90.8 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the Fly-Z+ Forged length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.