The Cobra Bio Cell Fairway runs from 43 in (109.2 cm) for the 5-7W to 43.5 in (110.5 cm) for the 3-4W.
Cobra Bio Cell Fairway length chart
Playing length in inches and centimetres.
| Club | Length (in) | Length (cm) |
|---|---|---|
| 3-4W | 43.5 in | 110.5 cm |
| 5-7W | 43 in | 109.2 cm |
Measurements are shown exactly as structured in the master length field, with centimetres converted from inches.
Length progression
A quick visual of the listed length progression within this model.
Bio Cell Fairway club lengths
Bars show the relative progression within this model, not a comparison with other clubs.
What the numbers mean
Playing length is a build specification, not a universal fitting target.
How this length compares
Only genuinely comparable Cobra entries are used; women, junior and ONE Length builds are not mixed with standard men’s builds.
Near dataset median
Based on 5 other Cobra men/unisex fairway entries with the same club label and ONE-length status in this dataset.
Length and setup information
A cleaner build snapshot of the model details and paired spec information.
Core model details
Loft and lie setup
About this length data
Cobra Bio Cell Fairway length FAQs
What is the Bio Cell Fairway length range?
The listed lengths run from 43 in (109.2 cm) to 43.5 in (110.5 cm), a total spread of 0.5 in (1.27 cm). The longest listed club is 3-4W and the shortest is 5-7W.
How long is the Bio Cell Fairway 5-7W?
The listed 5-7W playing length is 43 in (109.2 cm). Across this model, that sits 0.5 in below the longest listed club.
How many different lengths are listed for the Bio Cell Fairway?
There are 2 distinct playing lengths across 2 listed configurations.
How do loft and length relate in the Bio Cell Fairway set?
For the matched entries in this dataset, 3-4W is 13° at 43.5 in (110.5 cm), while 5-7W is 17° at 43 in (109.2 cm). That shows the actual model-specific loft/length progression rather than a generic fitting rule.
Is the Bio Cell Fairway length a model-specific factory-published figure?
Not in the source record used here. The master dataset flags the length as reconstructed from the nearest Cobra family/generation standard because a complete model-specific factory length table was not available. Treat it as a reference value and verify before cutting or ordering a shaft.