Personal Plea for Help
Hey everyone, I’m at my wit’s end here. My 2016 EZGO RXV has been acting up lately. It stalls out of nowhere and sometimes refuses to start. I’ve tried a couple of things, but no luck so far. Anyone else faced this issue? I could really use some advice!
Response
I feel your pain! I’ve been through the same ordeal with my 2016 EZGO RXV. After some trial and error, I found a few solutions that actually worked. One thing that really helped was making sure the gas pedal was fully up before turning the key. Let’s get into the nitty-gritty.
Solutions that worked for users
| Solution | Users Who Found Success | Personal Experience | Estimated Cost (USD) | Time Needed (Minutes) |
|---|---|---|---|---|
| Check the Battery Connections | 1 | Tightened the battery connections | $0 | 5-10 |
| Gas Pedal Issue | 1 | Lifted the gas pedal past “rest” | $0 | 5-10 |
| Brake and Accelerator Position | 1 | Pulled back on brake and accelerator | $0 | 5-10 |
Symptoms
- Golf cart stalls at random intervals
- Golf cart refuses to start
- Golf cart comes to an abrupt stop while driving
Possible Causes
- Loose or corroded battery connections
- Gas pedal not returning to its “rest” position
- Brake or accelerator pedals not fully up
Solutions that Worked
1. Check the Battery Connections
What I Did:
I inspected all the battery connections and found a couple of loose ones. I tightened them using a wrench.
Outcome:
The golf cart started running without any hiccups.
Personal Experience:
After tightening the battery connections, the cart fired up like a charm.
Estimated Cost:
$0
Time Needed:
5-10 minutes
Steps:
- Open the battery compartment, usually located under the seat.
- Inspect each battery terminal for looseness or corrosion.
- Use a wrench to tighten any loose connections.
- If you see corrosion, clean it off using a wire brush.
Expert Tip:
Always wear gloves when handling battery terminals to avoid any acidic burns. Also, it’s a good practice to disconnect the battery before tightening the connections to avoid any short circuits.
2. Gas Pedal Issue
What I Did:
I noticed the gas pedal wasn’t fully up. I manually lifted it past its “rest” position.
Outcome:
The golf cart started moving again.
Personal Experience:
I had to lift the back of the pedal up and past the normal “rest” position, and that did the trick.
Estimated Cost:
$0
Time Needed:
5-10 minutes
Steps:
- Check the position of the gas pedal.
- If it’s not fully up, manually lift it past its “rest” position.
- Turn the key to the “Run” position to engage the cart.
Expert Tip:
If you’re facing this issue frequently, consider lubricating the gas pedal mechanism to ensure smooth movement.
3. Brake and Accelerator Position
What I Did:
I made sure both the brake and accelerator were in their fully up positions before turning the key.
Outcome:
The golf cart started moving without any issues.
Personal Experience:
I had to pull back on both the brake and accelerator pedals a little while turning the switch, and it worked like a charm.
Estimated Cost:
$0
Time Needed:
5-10 minutes
Steps:
- Inspect the brake and accelerator pedals.
- Make sure both are in their fully up positions.
- If they’re not, manually pull them back to the up position.
- Turn the key to engage the cart.
Expert Tip:
If the brake or accelerator pedal is sticking, it might be time for some maintenance. Lubricate the pedal mechanisms to ensure they return to their up positions smoothly.
Extra tips
- Battery Maintenance: Regularly check the water level in your battery cells. Low water levels can also cause your cart to stall.
- Emergency Reset: Some EZGO models have an emergency reset button under the seat. If your cart is stalling, try pressing this button.
- Software Update: Believe it or not, some modern golf carts have firmware. Check if there’s an update available for your cart’s system.
Golf Cart Models Where This Worked
- 2016 EZGO RXV
- 2016 EZGO RXV 2+2 (AC)